Bandsaw Resaw Jig Centurion 22-915

Centurion
$14.99
Share
Description

This 90mm(3-1/2") high aluminum jig has been designed to adjust a board’s angle on the fly to match the blade’s drift. That drift issue comes often particularly on tall resaw cuts. 

Because the chips cannot be cleared, the blade tends to cut more on one side. Reasons are either the blade is dull, has too many teeth or the gullets are too small.

By using that single point attachment, you can realign the cut accordingly and complete it with satisfaction.

Comes with 2 knobs. 

Boss’ tip: To reduce drifting, adjust your upper blade guide as close as possible to the workpiece, aligned the fence with the table slot, use a wider saw blade with maximum 3TPI and make sure the blade is well centered on the upper wheel.

Over 70 years of Experience

Normand relies on a team of dynamic and experienced people ready to share their knowledge and experience with customers.

One Stop Shop

Normand offers a one stop counter concept where the customer can find the answer to all his needs for woodworking, from the large specialized corporation to the small cabinetmaker.

Great Expertise

Normand continually invests in the training and development of its staff. The acquisition of modern management and information tools as well as their status update on an ongoing basis is part of our commitment to excellence.