High Flow Blow Gun Topring 60350

Topring
$38.99
Share
Description

At the beginning, in the industry, blow guns were used by operators for cleaning their workstation and also to clean themselves at the end of the shift (a practice that is no longer tolerated). Today, blow guns are mainly used for cleaning parts, clearing chips and maintaining clean work areas.

Topring blow guns are considered among the most secured because they exceed OSHA requirements. If the nozzle is obstructed, a check valve located inside the mechanism immediately shuts off the airflow. When the nozzle is cleared, the valve snaps to release the air again. Thus a worker will never risk being exposed to a dangerous blast of air on his skin.

  • Its nozzle, venturi shaped, allows for a much higher air push (+ 250%).
  • In case of obstruction, the nozzle facilitates the evacuation of air from the sides allowing to maintain a pressure of 30 PSI
  • Nice blue gun equipped with ¼ NPT female connection and a 4"(10cm) long x ¼"(6mm) dia. tube
  • Its ergonomic conception reduces fatigue and symptoms associated to carpal tunnel
  • Consumes 10.2 CFM and noise level is 84 dB to 87 PSI 

Tip from the boss: For best results, operate by small jerky strokes

Over 70 years of Experience

Normand relies on a team of dynamic and experienced people ready to share their knowledge and experience with customers.

One Stop Shop

Normand offers a one stop counter concept where the customer can find the answer to all his needs for woodworking, from the large specialized corporation to the small cabinetmaker.

Great Expertise

Normand continually invests in the training and development of its staff. The acquisition of modern management and information tools as well as their status update on an ongoing basis is part of our commitment to excellence.